THE REVOLUTION OF AN ULTRA-EFFICIENT TECHNOLOGY

TM

Air Cooled

TMA CM

Circlemiser

TMA ES

Evaporative system

TMA FC

Free Cooling

TSA

Condensing unit

TMH

Water cooled

TME

Condenserless chiller

RCE

Remote condenser

Turbomiser from Geoclima is the most efficient chiller of its type on the market today: thanks to the use of Turbocor compressors, it is able to reduce energy costs by up to 50% compared with traditional units that use screw or reciprocating compressors. Turbomiser chiller has won several awards, including CIBSE, the most prestigious award for technology with low environmental impact.

In addition to ultra-efficient performance, Turbomiser improves comfort and productivity levels in buildings thanks to its innovative design and continuous monitoring. And, with its frictionless magnetic bearings, service and maintenance costs are significantly reduced.

The Turbomiser chiller is based on a combination of technologies designed to reduce energy consumption, minimise or avoid leaks, reduce refrigerant charge and ensure reliable operation and deliver quiet running:

  • inverter-controlled magnetic bearing compressors whose output can be precisely matched to load;
  • micro-channel aluminium condensers, which reduce refrigerant charge while increasing the effectiveness of heat exchange;
  • flooded evaporators, which ensure optimum heat transfer between refrigerant and water;
  • the use of a pumping system of the refrigerant, which significantly increases thermodynamic efficiency throughout the entire operative range of the unit;
  • inverter driven condenser fans to match performance to demand and reduce energy consumption;
  • a sophisticated chiller control system which integrates with that of the on-board integral compressor control to optimise performance of the system as a whole.
  • REDUCED ENERGY CONSUMPTION

    Outstanding energy efficiency reduces operating budgets and helps shrink a facility’s carbon footprint, thanks to annual energy usage 30% to 50% less than conventional screw or reciprocating compressors chillers. Exceptional Energy Efficiency Ratios (EER) and Seasonal Energy Efficiency Ratio (SEER) are assured.

  • REDUCED REFRIGERANT LEAKAGE

    Refrigerant leaks are useless, costly and entirely avoidable. They are a consequence of poor design and/or maintenance of plant. The Turbomiser is designed to minimise or avoid leaks altogether, through reducing the number of components and joints in the system.

  • REDUCED MAINTENANCE

    As a result of the oil-free design and limited number of moving parts, the Turbomiser requires no oil changes and much reduced servicing to ensure efficiency and reliable running. The technology is highly reliable and proven to save the end user cost and reduce down time.

  • COMPACT AND LIGHTWEIGHT

    The Turbomiser packs a lot of cooling power into a small space. Turbocor compressor weighs just 125 kg (275 lb) compared with 600 kg (1323 lb) for typical screw and reciprocating compressor chillers. This frees up plant rooms, reduces loading on rooftops and enables chillers to be sited in spaces considered too tight for standard chiller technology.

  • EXCELLENT PART LOAD EFFICIENCY

    The use of a variable speed drive enables chiller output to be finely controlled between 15% to 100% of capacity, enabling cooling to be matched precisely to load. Given that Geoclima chillers operate at part load the bulk of the time, this helps significantly reduce energy consumption and ensure effective cooling.

  • VERY QUIET OPERATION

    Noise is a growing issue, particularly with the introduction of air conditioning to buildings in built-up and residential areas. The Turbomiser addresses this through exceptionally quiet operation, down to 67dB at 5 metres. Due to its design, the Turbomiser chiller is also virtually vibration free: there is no need for anti-vibration mountings or special supports.

  • LOW START-UP CURRENT

    Conventional chillers may require up to 600 Amperes starting current, putting a huge draw on a building’s electricity supply, and sometimes requiring an expensive upgrade of the substation. Turbocor compressors only need 5 Amps to start, saving costs and maintaining headroom for other essential services.

Refrigerants